Originally Posted by Tordne
Tordne, I chose the Flash PCM licensing from the tune tool. At first it said something about not being able to connect then I refreshed and everything came up as normal.
How do I set the cable type to V1? I tried looking for it but could not find menu for that. I'll try and search for a way to do it in the mean time. Thanks.
Chris
EDIT: Screen shot in post below.
Last edited by Tordne; September 3rd, 2006 at 11:43 AM.
Andrew
EFILive Crew
Tordne, it says I do not have access to the screenshot link you provided. Thanks.
Chris
OOPS, that was posted in a special thread. I'll reports below:
Andrew
EFILive Crew
BTW, this is what it showed on the summary screen last time I tried connecting.
Summary
Supported parameters available 287
Validated modules available 9
System readiness test (EPA) Incomplete
Specifically monitored tests Not checked yet
O2 sensors tests Not checked yet
Diagnostic trouble codes Not checked yet
History freeze frames Not checked yet
Stream-Slow scan mode Supported
Stream-Fast scan mode Supported
Maximum dynamic packets 16
PCM
System Readiness Tests Results
MIL Status MIL_OFF
Number Of Emission-Related Trouble Codes N/A
Misfire Monitoring Ready
Fuel System Monitoring Ready
Comprehensive Component Monitoring Ready
Catalyst Ready
Heated Catalyst Not Supported
Evaporative Purge System Not Ready
Secondary Air System Not Supported
A/C System Refrigerant Not Supported
Oxygen Sensor Ready
Oxygen sensor Heater Ready
EGR System Not Supported
Specifically Monitored Systems Tests Results
Oxygen Sensors Tests Results
Diagnostic Trouble Codes
History data
So I change the controller ID and the Scan tool ID to what you have also?
It maybe that the version of software I have is newer, so the screen may look different.
All you should need to change is the preferred cable type, and uncheck the "Scan all cable types" box.
Incidently.. Did you try the Help->PCM Licnesng in the Tune Tool at all?
Andrew
EFILive Crew
Yeah, I tried the help- pcm licensing in the tune tool. Everything popped up as normal: the serial number, pcm licenses....
BTW, the screen looks pretty much the same but I also have the controller ID and Scan tool ID just like you. My controller ID says $10 PCM and my Scan tool ID says $F1
Oh yeah, preffered cable type was set to V1 but scan all cable types was checked. I'll try turning it off.
Last edited by foxySS; September 3rd, 2006 at 11:59 AM.
sitting in the truck right now. Still not working. The OBD light is flashing on the interface but no USB light.
Thats is just so weird... If the Scan Tool was able to read the interface the USB connectivity you would have to assume is probably OK.
What sort of truck is it (year, make, model, motor etc? What Operating System? And do you know that it is a supported vehicle?
Can you read the tune out with the Tune Tool?
Andrew
EFILive Crew
Posting Permissions
Reply With Quote