Shift Light in 2k F-Body?

[joecar]

Whoa ... getting these Pins is a major PITA ... I finally found the "original" parts, they're Delphi "Micro-Pack" connectors, sealed version, Delphi/Packard part# seems to be 12084913 ... (or 12084912 for 0.8mm^2 cable)

Now to the even harder part ... getting some

If found those online, can you post a link, I want to look at them.

Thanks
Joe

[ace68]

I think you should try out the co. I listed here in this post he's got what you need.

[Garry]

Do you mean like this:

http://www.powerandsignal.com/docs/C...es_Section.pdf

(Page 16)

[ace68]

I thought you were pluging into the PCM that connector looks lke something you would use inside the car. I was refering to the connecor components here:
Weather-Pack Connector Terminals

TerminalGenderCable RangePrice (each)Female18-20ga$0.25
Male18-20ga$0.25

[ace68]

I have some of these here I could check to see if those fit on the PCM terminal if you want.

[Garry]

I can't tell from the pics, but I think those will be too thick to fit in the plug, and too large to have the PCM pins connect reliably ...

[ace68]

oh yea they are way too big.

[Ira]

I can't tell from the pics, but I think those will be too thick to fit in the plug, and too large to have the PCM pins connect reliably ...

I have a reasonable quantity of the pins that fit the little black connectors you find on MB front panel connectors that plug onto .025" square pins. I can send you a couple of pins either uncrimped or crimped to whatever wire you want that I have in stock.

Ira

[Garry]

I've already tried with the PC-type connectors, while they will fit in the plug itself, they are to small to keep from pushing in deeper when being plugged in ... (got lots of PC supplies myself)
I should be able to get some similar ones from a place here in Germany, hopefully they will fit well enough ...

[ringram]

Just arc weld a nail on the pin and then use copper battery jumper cables to clamp onto the nail and the other end onto the pcm wire, just mind the hood clearance with the 3M, 200 amp cables.