Results 1 to 5 of 5

Thread: C0558 Trouble Code: "Calibration Data Not Programmed"

  1. #1
    Lifetime Member
    Join Date
    Aug 2005
    Posts
    710

    Default C0558 Trouble Code: "Calibration Data Not Programmed"

    Here's the scoop. I tuned an 06 Tahoe Z71 with Stabilitrak a couple of months ago by mail. Met up with the guy yesterday and adjusted the tune for his new, larger tires. Immediately upon re-flash, DIC shows that the stability control system has been de-activated. Pull the DTCs and see a C0558, "Calibration Data Not Programmed", Status: PHC, Module: ($29) "Electronic Brake Control Module (EBCM)"

    I'm assuming that the cause of this is much the same as when you drastically change tire size and the ABS computer begins to freak out.

    Has anyone run into this issue before? And if so, did you manage to get it fixed? Tire size increased by about 7.5%.

    Thanks,
    Justin

  2. #2
    Lifetime Member ChipsByAl's Avatar
    Join Date
    Feb 2006
    Posts
    617

    Default

    Looks like the fix is to reprogram the EBCM with GM equipment. This is according to GM service information.
    AL
    "Trash that carb and get Injected!"

  3. #3
    Lifetime Member
    Join Date
    Aug 2005
    Posts
    710

    Default

    Quote Originally Posted by ChipsByAl
    Looks like the fix is to reprogram the EBCM with GM equipment. This is according to GM service information.
    AL
    Then that's what I will recommend the customer have done.

    Thank you.

  4. #4
    Lifetime Member
    Join Date
    Aug 2005
    Posts
    710

    Default

    Ran into another one of these today. This was on a 2005 5.3L truck that had been previously programmed without incident. Calibration only flashed the PCM and his traction control is now non-existant. That makes 2 2006 trucks and 1 2005 that this has occurred on.

    Any thoughts Ross?

  5. #5
    Junior Member
    Join Date
    Jan 2012
    Posts
    11

    Default

    Any fix for this? Same problem 05 Silverado SS w/ 80e swap Stock tires wheels and gears

Similar Threads

  1. P2563 code "Turbocharger Boost Control Position Sensor Performance"
    By Truckin Stuff in forum Duramax 06 LLY / 06+ LBZ & LMM
    Replies: 0
    Last Post: December 3rd, 2009, 12:11 PM
  2. what table controls start up decay speed? "how fast it decays out"
    By mvvette97 in forum Gen III V8 Specific
    Replies: 4
    Last Post: March 19th, 2009, 11:10 PM
  3. EFILive "Classic"/"Legacy"/"Historic"?
    By emarkay in forum FlashScan V2
    Replies: 6
    Last Post: November 2nd, 2008, 01:48 AM
  4. "PCM is in an Unkown State" & "Reflash Failed"
    By foxySS in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: September 8th, 2006, 11:53 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •