PCM Locked
I have 2000 chevy truck with an LS1 that I programmed about a month ago and it worked great (EFI Live kicks ass). PCM set a check engine light for the EGR system that I dissabled and now is locked up. I can still connect with
scan tool but not tuning tool. It say operating system not compatible with
EFI live. Anybody got a bone to throw me????????
Call me! I have your fix.Originally Posted by tannerman
I have 2000 chevy truck with an LS1 that I programmed about a month ago and it worked great (EFI Live kicks ass). PCM set a check engine light for the EGR system that I dissabled and now is locked up. I can still connect with
scan tool but not tuning tool. It say operating system not compatible with
EFI live. Anybody got a bone to throw me????????
Sent you a email. Let me know how it works out for you.
PS - I see your name works now.
What going on Chad? I took week off. I tried reconnecting with those calibrations you sent me. Still does not connect. It acts like I need an unlock code.
Post up what error you get on this.
send me the tune, ill unlock or figure it out. You can try to type in $ffff in the key and try again.
"If you can leave a black mark on the pavement, from the exit of one corner to the braking point of the next one, you have enough horsepower."
PCM hardware # 0($ 0), not recognized. May occur for the following
-not a valid oper. sys. or cal.
-PCM not compatible
Tried $ffff no difference.
If it says the hardware is zero then the ffff should work. in the little windo what does it say the seed is?
"If you can leave a black mark on the pavement, from the exit of one corner to the braking point of the next one, you have enough horsepower."
It does not get that far, but the seed has always been ffff
Just email me your last tune you put into your computer. ill look and see what the key is
jessebubb@yahoo.com
"If you can leave a black mark on the pavement, from the exit of one corner to the braking point of the next one, you have enough horsepower."
Posting Permissions
Reply With Quote