LC-1 work with flashscan

[87gmc]

Going to order the LC-1 from the makers of LM-1. Will the LC-1 work with flashscan?

[Dirk Diggler]

As long as you have an analogue output Flashscan will work with it

[Blacky]

As Dirk said, you just need an analog voltage output.

On this web page:
http://www.motorsportsinnovations.com/wide_band_o2.htm
The LM-1 is shown with the following feature:
"0-5 volt output for any Data Acquisition system"

If the LC-1 has that same feature then it will work with FlashScan.

Regards
Paul

[87gmc]

Like the LM-1, the LC-1 has 2 analog outputs that you can freely program. Look at the LM-1 manual for details. The analog out programming of the LC-1 is identical. The only difference is that the LC-1 has separate grounds for heater and system. This way the ground offset issues of the LM-1 analog outs are minimized or eliminated. Also the output resolution of the LC-1 is 12 bits (~1.2mV) while the LM-1's analog outs are 10 bit (~5 mV).
The analog outs are completely independent of the serial stream that feeds the XD-1 or (future) LogWorks.

Regards,
Klaus

Found this on there website

[BowlingSS]

I just ordered a LC-1. VE table here I come...

Bill

[mistermike]

Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.

[BowlingSS]

Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.

Call Chris At:
APEngineering
586-954-3181

Bill

[mistermike]

Do you have to know someone to buy these. I signed up for their newsletter and check the site regularly, but there's no word on availability.

Call Chris At:
APEngineering
586-954-3181

Bill

Thanks, Bill!