Results 1 to 3 of 3

Thread: Why doesn't SAE.MAP not work? (2-bar)

  1. #1
    Senior Member
    Join Date
    Jun 2006
    Posts
    144

    Default Why doesn't SAE.MAP not work? (2-bar)

    I can read manifold pressure OK. But not SAE map (over 100kpa). Not a huge deal I guess I just wanted the data tracing to work especially on the dyno!

  2. #2
    Lifetime Member TAQuickness's Avatar
    Join Date
    Jan 2005
    Posts
    2,940

    Default

    I believe there are two MAP pid's - SAE and GM - and only one of them works for > 1bar. Have you tried logging both?


  3. #3
    Senior Member
    Join Date
    Jun 2006
    Posts
    144

    Default

    yes, SAE MAP reads OK but GM MAP is what the tables are link to.. or visa versa Thats what i'm saying.. data tracing doesn't work because of this.

Similar Threads

  1. "Paste & multiply" doesn't work?
    By Garry in forum General (Petrol, Gas, Ethanol)
    Replies: 13
    Last Post: December 20th, 2013, 12:12 PM
  2. 3 Bar MAP sensor doesn't work with 3 Bar scaling!
    By Redline Motorsports in forum General (Petrol, Gas, Ethanol)
    Replies: 23
    Last Post: April 27th, 2010, 04:21 PM
  3. Scan doesn't work after upgrade
    By ChucksZ06 in forum Gen III V8 Specific
    Replies: 12
    Last Post: June 2nd, 2009, 02:11 PM
  4. LC-1 doesn't work pass though
    By samh_08 in forum FlashScan V2
    Replies: 5
    Last Post: April 19th, 2009, 07:53 AM
  5. Replies: 15
    Last Post: April 14th, 2007, 06:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •