What amp do I need to run my bench top harness? some converters are as little as .5 amp. THANKS
What amp do I need to run my bench top harness? some converters are as little as .5 amp. THANKS
I don't know what the PCM draws, but I picked up a 15amp for $40-$50 a few years ago
Do you have an amp meter? I wouldn't expect the PCM alone to draw anywhere near .5Amps@12V ... haven't tried it, though ... my guess is somewhere in the 50-100mA ballpark ...
Garry Glendown * '17 Fifty 2SS MT * 99 Firehawk Convertible (for sale)
i've bench flashed using a 12v 3amp power supply, no problems
It's all good until it goes "Bang"
You need 12V with at least 1Amp. Make sure it is a regulated power supply.
Regards
Paul
Before asking for help, please read this.
Check radio shack. They have a regulated 3A with cigarette lighter plug as well a terminal plugs for under 50.
THANKS, for the replies
Is the PCM actually using that much power??? Heck, I'm running a complete quartermile timing system with 18 light barriers etc. on 22V/.580A ... (minus the 220V lights)Originally Posted by Blacky
Garry Glendown * '17 Fifty 2SS MT * 99 Firehawk Convertible (for sale)