Need a little help here , I just got my LC-1 W/B installed and working , was doing the AutoVE tutorial , got to the last and am confused , the tutorial states save the file as AutoVE_0000.tun , but then says preform a calibration only with SDAutoTune_0000.tun , where did this file come from ?
I am assuming that the data loged with the LC-1 is used to modify the SDAutoVE.tun that was created at the first of the tutorial , and then labled AutoVE_0000.tun .
EFILive AutoVE Tutorial EFILive V7 Scan and Tuning Tool
7. Hide all cells with a value of less than 50.
8. Select all cells in the table by clicking in the extreme top-left grey cell, then right
click and select Copy with labels (Shift+Ctrl+C).
9. Switch back to the EFILive Tuning Tool.
10. Open calibration {B0101} "Main VE Table".
11. Rigth click on any cell and select Paste->Paste and multiply with labels.
12. If you are tuning a 1999 or 2000 operating system then repeat steps 3 to 11 to
copy/paste the VE data from map [B] to the {B0103} “Backup VE Table”.
13. Save your tune as:
My Documents\EFIlive\V7\Bins\AutoVE_0000.tun
14. Peform a calibration only reflash of SDAutoTune_0000.tun into the PCM.
15. If necessary repeat the steps in the previous section, Data logging and this
section until the average cell values in your BEN map(s) are close to 1.00 (aim
for +/- .01).