Results 1 to 8 of 8

Thread: trans shift pionts?

  1. #1
    Junior Member JODAGR's Avatar
    Join Date
    Dec 2006
    Posts
    10

    Default trans shift points?

    I have a (01)2500 silverado with 6.0 I'm trying to move the shift points down at WOT because of a rev limiter I set at 4500rpm I changed parameters D0910-D0912 for 1>2 and D0915-D0917 for 2>3 also I changed D0940-D0952 And still I cant get the shift points for WOT below the rev limiter .Any help will be great.
    Last edited by JODAGR; January 5th, 2007 at 04:46 AM.

  2. #2
    EFILive Reseller wait4me's Avatar
    Join Date
    Aug 2004
    Posts
    1,348

    Default

    This is the Diesel section. For the trans to shift, it has to hit 2 perameters, Miles per hour Then / Or Engine RPM. Both conditions have to be met before Soloniod actuation will be made.
    "If you can leave a black mark on the pavement, from the exit of one corner to the braking point of the next one, you have enough horsepower."

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Also make sure the following are met:
    D0925-D0927 < D0910-D0912
    D0930-D0932 < D0915-D0917

    (about 10 mph difference is good).

    Edit: see correction (sorry I type badly)
    Last edited by joecar; January 5th, 2007 at 08:13 AM.

  4. #4
    Junior Member JODAGR's Avatar
    Join Date
    Dec 2006
    Posts
    10

    Default

    Hey thank you for the help ,I tried it this morning and it all works great. Sorry about putting it in the diesel section . Were should it go?

  5. #5
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    I'll move it to Petrol/Gas->General...

  6. #6

    Default

    Why did you set the rev limiter at 4500??

  7. #7
    Junior Member JODAGR's Avatar
    Join Date
    Dec 2006
    Posts
    10

    Default

    Company trucks,enough said right? Hey thanks joecar for moving it. I'm such a rookie!

  8. #8
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    No worries...

    See post #3 again, I corrected my stupid typo..., but you figured it out already.

    me-> <-typos

Similar Threads

  1. trans won't shift at WOT
    By lilicedout24 in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 7
    Last Post: February 4th, 2010, 09:54 AM
  2. G8 trans
    By minytrker in forum 6 speed/8 speed RWD/FWD Transmission Tuning (incl T43, T76, T87)
    Replies: 12
    Last Post: October 8th, 2008, 09:59 AM
  3. why 1>2 shift happens at higher rpm than 2>3 shift?
    By 350SS in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 1
    Last Post: March 13th, 2008, 10:54 AM
  4. Disable adaptive shift learning after Shift Kit Install
    By BlackGMC in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 3
    Last Post: January 24th, 2008, 04:49 AM
  5. trans shift pionts?
    By JODAGR in forum General (Petrol, Gas, Ethanol)
    Replies: 7
    Last Post: January 5th, 2007, 08:15 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •