Need help guys

[wickedcummins]

I do mostly cummins stuff but I could use some help here with my fox I do a turbo ls1 in.. I have a 04 harness and a 05 ecu that allows for thottle cable and iac control says the ls1.com site. I need a file thats going to allow me to tune with speed denisty and let me run the throttle cable and iac. I can find a good stock file for this..

THanks for the help in advance

[Tre-Cool]

1mb-411-flex.ctz

This will give you 2bar cos3 os, along with flex fuel support if needed. It's based on the 04 gto 1mb tune.

[wickedcummins]

1mb-411-flex.ctz

This will give you 2bar cos3 os, along with flex fuel support if needed. It's based on the 04 gto 1mb tune.

Thank you very much!
IS there now 3 bar support ?

This is the computer I am using as it has control for Iac and Throttle. LS1B stock filer.ctz

[wyochimneysweep]

that's a 24x file

[wickedcummins]

that's a 24x file

What's that mean? Sorry new to the gas tunes

[Tre-Cool]

all ls1b controllers are 24x - for crank reluctor wheel.

[wickedcummins]

all ls1b controllers are 24x - for crank reluctor wheel.

Ok thanks. Will that file you sent me work with a three bar? Can I just change the scaling of is there a custom os for 3 bar

[Tre-Cool]

that will cover 3 bar. just need to setup the map sensor scaling and you should be set.

[wickedcummins]

Thank you so much. I appreciate it. So I need to flash in the os also?

[Tre-Cool]

correct. full flash.