Need Help Wiring up Sm-AFR to V2

[Chalky]

Anyone clarify wiring diagram with SM-AFR?

The connector for the WB linear output has 4 outlets.
1: 3.3v
2: Grnd
3: WB
4: NB

1: As I understand it, the 3.3v will run to ADR1 in EFILive.
2: Will be the ground that goes to the ADR1 ground in EFILive.
3: I am using the WB obviously but there is no additional wires. The wide band connector plugs directly into the back of the SM-AFR
4: I will not be using NB monitoring.

Am I on the right path here?

TIA.

[Tordne]

Hey mate, what happened to the M-250?

[JezzaB]

I run the WB wire to the AD1 + connection. I was running the Ground from the SM-AFR to the AD1 -, but it was throwing out the result. I found that if I didnt use a ground at all on the AD1 - terminal it still worked and must use the ground that V2 gets from the OBDII connector

Jez

[Chalky]

Hey mate, what happened to the M-250?

I believe it died based on conversations with PlX. Now I am waiting on PLX to email me a RMA!!

FwIW, I think I have figured out the wiring, They have one of 4 pinouts labeled 3.3v with no explanation. After reading more, i find out that this is for a guage that they also sell a DM-5 I believe.

JMO but PLX leaves a lot to be desired when it comes to their hardware instructions.