I am using V1 and V2 off and on on the same late model XP laptop. I now lose connection during scan and can restore connection only by unplugging and repugging, but even this is a short lived fix. Should I be using different drivers for V1 and V2?
I am using V1 and V2 off and on on the same late model XP laptop. I now lose connection during scan and can restore connection only by unplugging and repugging, but even this is a short lived fix. Should I be using different drivers for V1 and V2?
2000 C5 Coupe, 6M, Callies/Mahle stroked LS7 (441), Blackwing, Halltech, LS3 intake, 90mm Shaner TB, ported L92 heads, FAST 50# inj, not too much cam, Kooks 1 7/8" headers , 3" catless mid pipes, Z TIs, track suspension, , 3:90 rear, EFI V2, LM-2, etc.
PowrMax Performance
100 mm PowrMAF
LM-2 EFILIve package with TAQ -sLM2 V-2 serial cable> Package deals
V1 and V2 should use the same driver package no problems.
Andrew
EFILive Crew
Ok, swell. Thanks
V1 seems to run with the 1.06s or V2s but it sure likes USB2 better than USB1, or so it seems.
It will drop scan connection in less than 200 frames most times if not using USB2 PCMCIA card while V2 does not seem to care?
Last edited by Bruce Melton; March 27th, 2007 at 07:19 AM.
2000 C5 Coupe, 6M, Callies/Mahle stroked LS7 (441), Blackwing, Halltech, LS3 intake, 90mm Shaner TB, ported L92 heads, FAST 50# inj, not too much cam, Kooks 1 7/8" headers , 3" catless mid pipes, Z TIs, track suspension, , 3:90 rear, EFI V2, LM-2, etc.
PowrMax Performance
100 mm PowrMAF
LM-2 EFILIve package with TAQ -sLM2 V-2 serial cable> Package deals