I don't know ?

[Chevy366]

Something I found out is that after AutoVE is finished and before Spread Sheet or Hand Smoothing , if you had increased the VE table by 15% then if you remove that 15% from the fringe areas that were not altered by the AutoVE values it makes a huge difference .

[5.7ute]

That would be due to the way the pcm interpolates between cells in the table. This is to give the pcm better resolution in the cell than what the physical size of the table will allow.

[Chevy366]

That would be due to the way the pcm interpolates between cells in the table. This is to give the pcm better resolution in the cell than what the physical size of the table will allow.

Figured it might be something to do with the interpolation of the cells but was not for sure .
So enhances resolution , thanks for the explanation .