auto ve problem

[woody69]

I have followed the righten and interactive to the best I can and when I paste and muptli with lables the b0101 goes flat at 500.00. On my loged bens I have some 600 and 500 from 1200 to 2800 RPM and at 20 t0 35 MAP.
Thanks Woody

[Doc]

Sorry I don't follow your question. Could you elaborate?

[joecar]

Post pics of your BEN map.

[Chevy366]

I have followed the righten and interactive to the best I can and when I paste and muptli with lables the b0101 goes flat at 500.00. On my loged bens I have some 600 and 500 from 1200 to 2800 RPM and at 20 t0 35 MAP.
Thanks Woody

Your BIN factors probably don't match (kPA versus PSI, Imperial versus Metric ) .
I think there is a 3D presentation of how to do VE in the Download section of Main or Home page of EFILive .

[joecar]

Good point.

[vatman02]

i had the same thing happen yesterday i forgot to change to average and pasted and multiplied the cell count

[woody69]

when i clicked average it 0.00 everything out.

[vatman02]

if it zeroed out then that means it didnt log any data make sure you have the correct pids selected if there is a line through any of the pids on your map screen then they have not been selected or as stated above make sure your pids match your MAP

Your BIN factors probably don't match (kPA versus PSI, Imperial versus Metric ) .
I think there is a 3D presentation of how to do VE in the Download section of Main or Home page of EFILive .

double check everything then do a new log the one you have is no good theres no data

[woody69]

OK thanks for the help. Now when I clicked the averaged button my averages were around .70 now do I have to go through the auto VE process a few times or am I doing something else wrong. How should I drive when I am loging for this, normal or hard . Thanks. Woody

[Chevy366]

Hard , normal , fast , slow , WOT second and third gear pulls , loading with the brakes (but be careful loading with the brakes , they can get hot) what ever it takes to hit as many cells as possible , the more the merrier .
You can't hit every cell in the VE table some are just way out of the rpm range and some are just above idle with some weird loads .