Am I doing this right?...........

[FreddyG]

So you were logging directly into your laptop? Do you have the corrupted log ? If so post it up.

I would, but after I saw that I wasn't getting anything but the three cells, I just shut it down until I could get on here and see if anyone knew what was the matter. I knew the gauge was reading the AFR, but the laptop wasn't logging correctly. That's why I thought it was the software.

I double checked my connections and they appeared alright, so I thought that maybe it was a pid conflict or some software issue.

Possibly this is the issue:

Regards
Paul

I'll check that! Thank You Paul and also Thanks to you also Mick!

[5.7ute]

One other thing. You didnt have the hide empty cell button active did you?This can give the impression that a cell isnt reading when in fact it just doesnt have enough counts to read.

[FreddyG]

I don't think so. Wouldn't it say in the title that empty cells are hidden? If it would, then I honstly don't remember, but don't think so.

I just checked my measurement units and all of them are set to metric. Maybe I'll try and log tomorrow some.

Thanks agin Guys!