Mafless TC Off after Operating System Patch?

[Acer]

Hi All,

Finally got around to playing with Mafless (SD) tunes on my 05 HSV GTO (LS2 E40) & got it to run Ok. One odd thing I noticed is that the traction control switches to off mode even though I have applied the Operating System Patch B9902 & did a full re-flash before applying the revised tune . Has anyone else experienced this issue & are there any suggestions on how to overcome the problem?

Thanks,

Acer

[GMPX]

I've not heard of anyone else having that issue yet.

Cheers,
Ross

[Acer]

Thanks Ross. Are there any particular "tricks" after the full re-flash that I may have missed?

Cheers,

Acer

[GMPX]

No not really, the only thing I can think of is there is a torque value out of whack causing the ECM to send the TCS disable message. Have you maxed out all the torque settings?

Cheers,
Ross

[TuneMaster]

It's ok to max out the torque settings on a manual. TCS still works after the patch. Have done a few without any dramas here. Post your tune file so we can have a look.

[Acer]

Thanks Guys, I think what it might be is that I didn't max out all the torque values in the TCS settings. I'll set them all to 8192 or whatever the max value is & see what happens.

Since my GTO is an M6, does it mean that the traction control will still be operative & effective once the torque settings are increased?

Many thanks,

Acer

[TuneMaster]

On M6's I always max out the torque values. TCS still works when on. I always apply the maf error patch as well as the traction control patch., even if i'm running mafless.

[Acer]

Thanks TuneMaster, that worked .

Cheers,

Acer