When disabled, the PCM will always use
- {B3605} Commanded Fuel When in Open Loop (Normal) or
- {B3647} (not available in this operating system) as the fuel mixture table without any O2 feedback as long as table
- {B4205} Closed Loop Temp Enable is also set to it's maximum value.
If this parameter is enabled then O2 feedback (STFT) will be used with the Open Loop table.
If you wish to run total open loop disable this parameter and set
- {B4205} Closed Loop Temp Enable to it's maximum value.
Only the following values may be entered into this table:
- Disable
- Enable