Results 1 to 2 of 2

Thread: 97-98 remove drive by wire

  1. #1

    Default 97-98 remove drive by wire

    Hey all gday

    I'm in the mood to rework a wirng harness from a 97 corvette, I would also like to remove the drive by wire and go to a cable, it is a conversion into a Jeep. What are some issues that you have seen with this?
    Just one guy tryin' to make a difference

  2. #2

    Default

    Well maybe to say in the mood was a little out there. I have a 97 vette harness that I need to rework and I need information on if it can be done with the harness, I assume that the PCM is still looking for the TP and that it still thinks that it is operating an IAC, I just wonder if I should be looking at just doing a new wiring harness and PCM I found that a company www.fuelinjectionconnection.com and www.hotrodlane.cc offer harnesses for swaps, the hotrodlane is quite a bit more money, ideas????
    Just one guy tryin' to make a difference

Similar Threads

  1. 2002 drive by wire tune
    By s10mods in forum Gen III V8 Specific
    Replies: 6
    Last Post: March 24th, 2010, 12:11 PM
  2. help! convert to ETC/drive by wire
    By DURAtotheMAX in forum Gen III V8 Specific
    Replies: 25
    Last Post: June 17th, 2009, 07:46 PM
  3. EFI Connection 24x Electronic TPI/LT1 Drive-by-Wire Throttle Bodies
    By S10Wildside in forum Conversions / Aftermarket Parts
    Replies: 0
    Last Post: May 26th, 2009, 12:52 PM
  4. Drive by wire motor
    By 91LS1S10 in forum Gen III V8 Specific
    Replies: 0
    Last Post: December 14th, 2008, 07:46 PM
  5. Should I remove the resistor out of my SLP MAF
    By esco35m in forum Gen III V8 Specific
    Replies: 3
    Last Post: August 11th, 2007, 08:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •