and how much do you smooth by.
Also what would you conisder a dialed in car? A BEN_Factor of +/-2% or are you all going grey trying to get the to 1.00
I have recently tried smoothing by 70% and it seems to be too much but the table looks good. I don't know how we can smooth the ve table to get it to look good and still retain the +/- 2% that we need. Not unless we just need to keep going over and over on it until it falls into place.
I believe the same as I was double checking the idle on a car last night. I had approx 43 after the Ben Factor, but after I smoothed the table 70%, it jumped up to 47 and messed up the actual afr. I know that there is a reson for a smooth ve table, but how can we get it to be smooth without it altering the actual afr? I flashed this car a total of 9 times to get it all dialed in and after the 9th time, smoothing and all, the idle was still out 4% and only started about 6% out.
I don't have my laptop with me or I would post a screen shot of mine as well. My VE table is smoother, but my ben factor doesn't look near as close. Now if I don't smooth the table, then it falls right into place. It appears the question again is, how smooth does this table have to be? We know the mafless GTS using a spikey table but we hear again how they interpolate and the table needs smooth...... What were you using here to smooth, 50%????