Sorry Ross but have you guys had a crack at the Trans Cal yet?Originally Posted by GMPX
Jez
Sorry Ross but have you guys had a crack at the Trans Cal yet?Originally Posted by GMPX
Jez
I was using this Cal file today on a new SSV and found that a lot of the PIDS were not supported when scanning such as octane scaler, burst knk and all the individual cylinder knk retards among others.....are these yet to be programmed into the cal file or something......?
Mike
"Just a tune > yeah right !!!! "
Eeerie!!, I just added them in today. PM me your Email address and I'll forward the file to you (gm_enhanced) file.Originally Posted by The Alchemist
Cheers,
Ross
I no longer monitor the forum, please either post your question or create a support ticket.
Should get it complete by the end of this week.Originally Posted by JezzaB
Cheers,
Ross
I no longer monitor the forum, please either post your question or create a support ticket.
How did you go on getting the Tras Cals done?Originally Posted by GMPX
Slowly, sorry guys.
The minute they are done I will post them up in the Forum.
I no longer monitor the forum, please either post your question or create a support ticket.