Dry Tuning Questions

[joecar]

Steve, if you have any logs we would like to see them.

[Beer99C5]

Steve, if you have any logs we would like to see them.

Me too

[oztracktuning]

PM me your email addresses.

[VYSSLS1]

Steve,

Almost completed the latest NOS install, 6 vehicles in total minimum shot 150hp after being on the phone to Paul and Ross, absolute ledgends , we have now a NOS multiplier high enough for the 250hp dry shot, the vehicle isnt completed yet, as the new clutch let go on the dyno. I will keep you posted steve on the overall power output, so far torque figure is 1085 engine tq @ 4200rpm and 415rwkw @4200rpm. Expected power figure will be approx 480rwkw@6000rpm with peak torque 1100nm's @ 5000rpm.

[oztracktuning]

Hi Brad
I am supporting a car with goodies soon that wants to run a 300 shot in a forged engine (wet). It should be good for a sub10s pass.

[WHYTRYZ06]

How do you determin how much to ad to the ve multiplier table in cos5 for say a 2 stage 175 dry shot???

[Beer99C5]

Spray the shot and enter the data into the spreadsheet, then modify the VE multiplier, then log again and walk it in to where you want it, by entering your new log info.

OZ has used it, I am using it mid Mayish

http://www.retrorelics.net/jim/Board...703DLFeb08.xls

[oztracktuning]

It might be a car by car thing. The amount thats needed my car can just get away with a 150 shot dry. But its fuel pressure drops from 58psi to 40psi !!!

The enrichment amount for it is 30% ie 1.300 - but if the pressure stayed steady at 58psi then maybe it would only need a smaller amount of enrichment because my values are inflated by the dropping fuel pressure.