Originally Posted by
Gelf VXR
AutoVE how to for the LS2 E40 PCM using EfiLives AutoVE tutorial
Create an AutoVE MAP
Note the following
8. Select Engine RPM from the parameters drop down list
10. Open calibration {B0200} Main VE table
11. The following labels should appear in the Col labels field:
,400,800,1200,1600,2000,2400,2800,3200,3600,4000,4 400,4800,5200,5600,6000,6400,6800
13. Select Intake Manifold Pressure (kPa) from the parameter drop down list
14. The following labels should appear in the Col labels field:
,15, 20.5, 26.3, 31.8, 37.5, 43.1, 48.8, 54.4, 60.0, 65.5, 71.3, 76.9, 82.5, 88.1, 93.8, 99.4, 105
Repeat process for BEN_LC12. It is possible to logs BENS on both banks
Set up Open Loop, Speed Density
SPEED DENSITY TUNE
VE TABLE {B0200} + 10%
MAX VE {B2030} + 10%
DFC0 enabled below {B0247} set to -40
DFCO enabled above {B0248} set to 122
PE MODE {B3618} set to EQ 1 (14.63)
OPEN LOOP COMMANDED AFR: IVT MULTIPLYER {B0146}
COMMANDED FUELS MUST BE SET TO EQ NOT AFR (WILL NOT FUNCTION
CORRECTLY IN AFR)
Look down the columns labeled
65 kPa all values less than .11 to .104 (14.06)
70 kPa all values less than .11 to .108 (13.54)
75 kPa all values less than .12 to .112 (13.06)
80 - 100 kPa all values less than .12 to .113 (12.95)
LTFT MAP DISABLE below {B1510} set to 110 kPa
LTFT ENABLE above {B1508} set 122
LTFT DISABLE below {B1509} set to -40
CAT PROTECTION {B0804} set to no
MAF HIGH FAIL {C0301} set to 2
MAF LOW FAIL {C0302} set to 1
MAF HIGH FAILURES {C0303} set to 1
MAF LOW FAILURES {C0305} set to 1
COOLANT TEMP CLOSED LOOP ENABLE {B1502} change from
85.000000
80.000000
75.000000
65.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
55.000000
All to 122
Save and upload, Don’t unplug MAF, start engine and check for DTC's to indicate MAF failure, any of P0101, P0102 and P0103. Clear DTC's. Return to SD tune set P0101, P0102 and P0103 to NO MIL, save and upload