E38 PCM Pinouts

[vxchev8]

Hello

I'm after a copy of pinouts for the E38 PCM. If anybody has a copy could you please post it up .
I have searched high and low on the net without success.

Cheers

Les

[ntae]

Have done the same thing few months back & no luck

[eboggs_jkvl]

I think you just needed to be looking in the correct location. Try here:

http://www.ls2.com/forums/showthread...40#post6553040


Elmer

[ntae]

Thanks

[eboggs_jkvl]

Sure thing. The E38 pinouts are listed as 2007 Vette E38 01-06. The Other pinouts are for the 2005 GTO (LS2)

[vxchev8]

Thank you eboggs_jkvl

[04colyZQ8]

I am looking for E40 PCM pin outs for the Trailblazer 5.3 or 6.0 I especially need the pin outs for requested torque and delivered torque to the ABS module. I need this info to see how to wire a 2004 Colorado harness to it thanks!

[gmh308]

A very good source:

www.repairprocedures.com

Most/all models covered.

[04colyZQ8]

Thanks! That is an awesome website! Do you know if you can change the pinonts in the programming? I think the Colorado uses the same plug but the order of the pinouts are different? Thanks

[gmh308]

Thanks! That is an awesome website! Do you know if you can change the pinonts in the programming? I think the Colorado uses the same plug but the order of the pinouts are different? Thanks

You're welcome. Pinouts are generally based on the specific calibrations.

What engine in '04 Colorado? Dont think E40 arrived until about 05.

Also, without checking for sure, I'm vaguely recalling that torque messages are delivered to ABS via the CAN on E40.