Auto Tuning - Step-by-Step

[ehradek]

so went through auto tune instructions but i do not have a wideband. i did notice right side o2 reading higher voltage than left. engine runs great with throttle but terrible at idle. i messed with ve tables today lowering them which seemed to help smoke but had a hard time idling. any help is appreciated.

[timweber]

so went through auto tune instructions but i do not have a wideband. i did notice right side o2 reading higher voltage than left. engine runs great with throttle but terrible at idle. i messed with ve tables today lowering them which seemed to help smoke but had a hard time idling. any help is appreciated.

Did you have any luck with tuning this? I have a similar set-up in a Z71 I am trying to tune. I get to the step where I need to adjust Table B3605. This table doesn't exist in my tune. Does anyone know what I should do next? I am new to this. Thanks!

[nonnieselman]

Did you have any luck with tuning this? I have a similar set-up in a Z71 I am trying to tune. I get to the step where I need to adjust Table B3605. This table doesn't exist in my tune. Does anyone know what I should do next? I am new to this. Thanks!

It says in the tutorial
"11. If your tune contains {B3605}, open calibration {B3605} “Commanded Fuel When in Open Loop”"

Post up your tune.
Are you using any of the Custom Operating Systems?