Quote Originally Posted by Patches
OK, thanks, Joel, there's one value I did not change - MAF High Freqency Fail Limit {C2902} to "1".

I'm not getting the MIL because of the disabled P0103, P0102 and P0103 DTC MIL Enablers are set to No MIL per the AutoTune instructions posted here.

I take it you left your MAF connector plugged in in OLSD and it was still disabled with the IAT functional???

Thanks.

Ed
I left the P0103 MIL on... if it's displayed you are in SD.

My MAF is still plugged in. The IAT is functional and my MAF still reports - but it is in SD. I had the "Reduced Engine Power" until I set the Fail limit to "1".

You will love the throttle response!!
Good Luck!

Cheers,
joel