Hi i am running efi-live V4 pro (licensed :-) )in my HJ monaro.
It is running the 165 ECM and the $12 VR def and 5.0lt engine
Also using a USB datalogging cable and Ostrich 2.0.(not at the same time)
Everything works fine.
I can connect efi-live with no problems and all displays work.
I select "engine data" in macros and turn ignition to "on" and data flows as normal.I select "charts" and "toggle logging on/off" and data flows and shows traces on chart display.
When i start vehicle data trace is still flowing until about 15 secs into logging and then i get " com time-out" or "Can't write to Com4. A device attached to the system is not functioning"
It seems to always happen when vehicle runs after a few secs.
Would having the "checksum disabled" through Ostrich 2.0 effect this or is it a timing issue?
I've tried the Eval version thinking it's just the amount of logging time eg 30 sec limit.
Now have the pro license (which i wanted anyway)and still the same issue....so much time trying ways to datalog in the last 2 months it's driving me nuts
I know its a problem on my side,not EFI-live......HELP!!!!
Thanks for any advice.....Mario