boots up ,,, within 3 seconds shows
scan tool
tune too,
diagnostics
options
boots up ,,, within 3 seconds shows
scan tool
tune too,
diagnostics
options
Ok, now start the Scan&Tune software, goto F6 Device Settings, goto F8 Serial IO tab, set Com Port to Wideband, set Wideband to Innovate, Save [to file], Program [into your V2], exit from Device Settings.
Now connect the LM-1 to V2 via the supplied serial cables joined using a null-modem adapter (or a cable made like this)... it specifically has to do the "null modem" Tx/Rx wire swap...
Power up your LM-1, your V2 should show the AFR/Lambda/eqr (dive down the menus to the right screen).
If you want to do BBL/BBR, then in S&T goto F5 Black Box Settings and set up the pidlists/pids/PCM/TCM on the Scan Data tab, and set up the PCM on the Tune Data tab (if you have manual trans leave the 2nd controller blank).
Why do they make this so complex,. Pids and files save here update that,. I love my motec! Thanks joe i have wasted your time lm1 is frozen im ready to smash it to peices, i cant win. I got the plx out now trying to figure a cable out for it is there a way i can use it without that stupid chip on serial port. Which i cant find anywhere. ?
Without the serial modification to the PLX device you can use it with the 0-5 volt A/D input on the FlashScan device. The downside of course is the more complex wiring, and more importantly the less accurate readings.
You have probably spent the money already, but these are the devices that are serially supported (http://www.efilive.com/index.php?opt...138&Itemid=143). I personally have 2 x LC-1 controllers, but I'd probably go the TechEdge route next time...
Here is a thread on the serial mod for the SM-AFR (http://forum.efilive.com/showthread....Serial-upgrade).
Andrew
EFILive Crew
JAW
Website: Unknown
http://14point7.com
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Thanks for that . Have updated the page now, and am adding the ECM and Zeitronix a well which are supported.
Andrew
EFILive Crew
thanks all !!!!!!!!!!!