512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
You would need to crimp the RJ45 end for the V2.
I ended up buying a set of crimpers from Radioshack when the clip for the RJ45 plug broke.
They have been used at least 2 more times since.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
I do have a crimper Just need to get wiring order and hope they have the same amount and order of pin at the obd2 male end
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
Big thanks to you Mr.P! I just hope the I will be ordering from them has the correct pin on the OBD2 plug end
The OBDII end should be standard.
Make sure to double check the wires for the corresponding pins.
512k RoadRunner Firmware 12.14R
FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
LC-1 WBO2
_________________________________________________
The cable pins for FlashScan are shown here:
http://download.efilive.com/Tutorial...20Tutorial.pdf
Regards
Paul
Before asking for help, please read this.