E67 missing PIDS from new Beta?

[scdyne]

E67 controller ?
It's not listed under "Select Vehicle" so I modified my Options.ini

But it wouldn't show up for anything. Is the list limited to 14 items only?

I just removed them all and made my own list of custom PSLs for my car.

Then I wanted to add some pids, but the auto generated E67_PIDs.txt contains only MONDTC and the FlashScan V2 hardware inputs/outputs.

E67.pmm Size = 3.46kb

Can I just hijack the E38.pmm and pretend/assume all is good?

also in the E38_PIDs.txt for the E38.pmm is found this:

INPHAB2      [1] Intake Cam Phase Actual Angle Bank 2 (°)
EXPHDB1      [1] Exhaust Cam Phase Desired Angle Bank 1 (°)
INPHDB1      [1] Intake Cam Phase Desired Angle Bank 1 (°)
EXPHDB2      [1] Exhaust Cam Phase Desired Angle Bank 2 (°)
INPHDB2      [1] Intake Cam Phase Desired Angle Bank 2 (°)
EXPHEB1      [1] Exhaust Cam Phase Error Angle Bank 1 (°)
INPHEB1      [1] Intake Cam Phase Error Angle Bank 1 (°)
EXPHEB2      [1] Exhaust Cam Phase Error Angle Bank 2 (°)
INPHEB2      [1] Intake Cam Phase Error Angle Bank 2 (°)

What/which one (where) is supposed to be:
Intake Cam Phase Actual Angle Bank 1 (°)
Exhaust Cam Phase Actual Angle Bank 1 (°)

So far using the E38.pmm I'm having good success with the stuff I know to be in the E67, but how much of the E38 is the same as the E67? I'm assuming most if not all? hopefully..

[Blacky]

E38 and E67 PIDs should be very similar. I'll get the E67 PID list updated asap.
I'll also look into the cam angle PIDs.

Regards
Paul

[Blacky]

I accidentally left off a few cam PIDs, I have added them in.
Regards
Paul