lc-1 to v2 hook up

[W_D_R]

Been searching for hours and can not find a definite on how to hook up my lc-1 wideband o2 to the v2 box.

I found a post a few months back that had a picture of the v2 inputs and showed where each pin goes. Not sure what forum but if someone could help me out, Thanks.

Wes

[nonnieselman]

im lookin for that too... my VE table is a lil screwy and i cant find anything about hookin up the LC-1 or LM-1 to my V2...

[mr.prick]

http://forum.efilive.com/showthread.php?t=564

[nonnieselman]

mr.prick.... we are tryin to figure out how to connect our LC-1 to our V2 flashscan.. not a V1..
Thanks for helping though..

[nonnieselman]

just incase you didnt see this...


http://forum.efilive.com/showthread.php?t=7616

[mr.prick]

sorry,
i figured it was a sticky with 13 pages and surely it
would have something for the V2 as well.

[Gelf VXR]

Look in the Beta BB logging forum pages, the LM/LC-1 can be connected to V2 serial port with the aid of an adapter. Of course you have to upgrade to the beta software

[joecar]

Turn the V2 over and you will see the decal as shown in the attached pic...

Choose (say) EXT.AD1... using the orange terminals that came with your V2, connect the WB signal wire to the pin with the + symbol, and the WB signal return/ground to the pin with the - or ground symbol.

[BlackSS]

What about the other 4 wires? I need mine to be portable and I can't find out how I need to wire it.

[nonnieselman]

What about the other 4 wires? I need mine to be portable and I can't find out how I need to wire it.

what 4 wires? on the control box?

look at your Tutorials.. it tells you where the wires go.. just put 1/4" spades (male / female) and just unhook them. thats how mine is set up. just keep your colors the same on both sides.