there is no fuse, i am bench flashing it. i read the TIS message about the adapter, don't have it but if you can get me the pinout that would be great. don't know what i am doing wrong, but presumably i am not pinning the blue connector properly. like i said it flashes but doesn't complete correctly. and it's not the ECM bc i have a couple and they act the same.
-alex
ok, i found out this is a known issue. this ECM can't be flashed with J2534 system i am using, presumably only tech2. just wasted so much time on this p-o-s box for nothing...
thanks anyway.
-alex
I was just about to post that you need to make sure every +12V input to the ECM is connected, sometimes different parts of the ECM's are powered from other inputs.
But, looks like you found the problem anyway.
I no longer monitor the forum, please either post your question or create a support ticket.
I will give you the pinout and then you will see.
I use other J2534 devices on these.
ok, thanks.
CAL ??
A Calibration method used by GM Powertrain and owned by Delphi
Delphi publishes a list of known micro/compiler combinations that have been used with CAL ??
?? has worked with Delphi to ensure that the output of the ??7 C compilers (Metroworks and Cosmic) comply with CAL ??
?? has verified a conversion tool to generate an output file from our ??9 compiler to be used with CAL ??
OK Then look at this
http://iam.delphi.com/en-us/servicea...ts/reflash.htm
http://iam.delphi.com/en-us/news/fea.../flashtool.htm
you are not using a Y cable by any chance Alex?
this is the EASE system. i am using it. according to EASE themselves, it does not work on siemens. i spoke with them, and it is listed as a known issue:
http://www.obd2.com/support/reprog/r...cle-issues.htm
but if you say it works with your pinout, email me the pinout and i'll try it...
what's a Y cable? i am using a blue J1 extension pinned for siemens. i tried it in "off-board" mode using the EASE off-board raw cable (i have it set up for attaching different extensions). and also on-board mode using a bench harness powered by 12v (a la mike's eficonnection.com setup). same deal, flash doesn't terminate properly and cycles back to beginning.Originally Posted by CalEditor
DLC #2 CL2 goes to pins #18 & #59 BLUE
DLC #4 & #5 Ground goes to pins # #3, #15, #25 CLEAR and #60 BLUE
DLC #16 B+ goes to pins #19 & #83 BLUE
IGN pins are #20 & #21 BLUE
Active pins are #17, #49, #50, #51, #57 CLEAR (they are all 5V ref)
After the programing is completed turn the ign off. DO NOT REMOVE B+ UNTIL THE 5V REF IS GONE!
I have 2 LED lights that stay on and you are not to disconnect the battery or PCM until the lights go out.
Posting Permissions
Reply With Quote