Results 1 to 5 of 5

Thread: Adjusting O2's for LT Headers?

  1. #1

    Default Adjusting O2's for LT Headers?

    Anyone done any tweaking to the O2's to compensate for them being further down stream on LT Headers? If so what numbers did you change and how much?

    Aaron.
    Aaron L.
    Conover, NC

  2. #2

    Default

    This has been resolved, Custom one off headers that had the O2's too far downstream. I never could get the transport delay to adjust correclty enough so I just relocated the O2's back up in the collectors where they should be and all is fine.
    Last edited by trudynosports; June 18th, 2006 at 01:05 AM.
    Aaron L.
    Conover, NC

  3. #3
    Lifetime Member GMPX's Avatar
    Join Date
    Apr 2003
    Posts
    13,148

    Default

    Aaron, what is the actual problem you are having?, is it setting O2 codes?.

    Cheers,
    Ross

  4. #4
    EFILive Distributor dfe1's Avatar
    Join Date
    Jan 2005
    Posts
    837

    Default

    Oxygen is oxygen and the amount in the exhaust stream isn't likely to change much between the inlet to the header and the sensor. What's more important than any other consideration is the exhaust flow past the sensor. That's a function of sensor position relative to the flow path (not distance from original position). If the sensor is positioned near a vortex or eddy, it won't provide an accurate reading because it isn't sampling a homogenous mixture. Sensor errors will therefore vary from header to header and vehicle specific testing will be required to determine what, if any adjustments are required. Unfortunately, if the sensor is near a vortex or eddy, flow past it won't be consistent so the degree of error will vary according to total exhaust flow.

  5. #5

    Default

    Bank 1 is not changing enough. Not the O2 sensor itself, tried in bank 2 and it works. No exhaust leaks, no CATS. ?? I'm still working on this one.

    Aaron.
    Aaron L.
    Conover, NC

Similar Threads

  1. adjusting allison shift
    By dezzi in forum Allison 5 & 6 Speed
    Replies: 6
    Last Post: February 1st, 2010, 09:29 AM
  2. Adjusting fuel used
    By rgullett83 in forum Duramax 06 LLY / 06+ LBZ & LMM
    Replies: 10
    Last Post: May 28th, 2009, 12:09 PM
  3. Logging for adjusting B1010
    By Cougar281 in forum Duramax LLY
    Replies: 2
    Last Post: March 9th, 2009, 09:42 AM
  4. speedometer adjusting
    By HioSSilver in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: February 7th, 2007, 11:57 AM
  5. Adjusting for weather while autotuning?
    By Chris81 in forum General (Petrol, Gas, Ethanol)
    Replies: 15
    Last Post: March 27th, 2006, 10:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •