OK, I've updated to the latest BB and firmware, all has gone OK so far. I've noticed a couple of things though....
- I get nothing showing up in the "select PID" screen. As previously, I formatted the config files-system in the V2 then copied over the files. I did use my old options.ini file as I couldn't see a significant difference.
- DVT for the E38 is there !!!! Woo Hoo I've tried a few options out and they seem to work OK, except for the "Idle Speed" adjust. As soon as I activated it the revs rose to 1000 and slowly climbed. No amount of adjusting made any difference.
- Flash speed for the E38 is *HUGE* now. A full 256kb cal flash was done in 50 seconds! Previously it took about 2:30.
- Power saving mode works again.
It's all looking pretty good, all I need to know is what the go is with the PID selections. Any ideas?
Simon