I've got flashscan2, about to add a wideband in the mix. Which wideband are you guys using?
I've got flashscan2, about to add a wideband in the mix. Which wideband are you guys using?
07 Silverado DMax Classic
02 Z06 LS3 416, 805rwhp, TFS245, Wiseco, Callies Crank/Rods, Iskendarian Lifters, Crower Rockers, FAST102/90, ATI Damper, 1-7/8 Kook's LT, QkTime Shield,Tolle-Fab 8pt
Old Engine: 1/4mile = 9.6/146 New Engine:?
EFI Live Tune/Scan v7.5.27, EFI Live Scan and Tune v8.2.23, build 276, BootBlock 2.07.06, FirmWare 2.07.52, 512K RoadRunner (12.14.R), Innovate Serial LC2x2
COS5/12212156 For 2002 Z06 Manual Vette
Im using a PLX with a circuit to interface with V2 (TTL to RS-232)
AEM and it sux!
Just hooked up my LC-1 to the serial input yesterday and works like a charm
I'm using a TechEdge 2J1 unit.
I did try a PLX and found that the analogue signal suffered a bit from earth off set errors, but using the serial interface fixes that. the Tech edge on the other hand has an earth reference in-put that adjust the analogue signal for any earth off set. Logging both the analogue and serial data shows them to be equal.
Simon.
<-- LC1 here
Dave
-'07 Acura TL Type-S
-'07 Honda Ridgeline RTS
-'00 Pontiac Trans Am WS6