-
need help bad
ok guy i am new to this i have never tuned or used efi live befor.
i just finished the motor for my truck it is a 01 silverado with the 5.3l.
mods are:
243 heads
cam 211 218 with a 114 lob sep and a 114 center line
p&p tb
lt headers and cat back
k&n cai
i have v1 scan and tune
on stock program have to give gas to start and it runs like crap.
i have messed with it and now i cant even get it to start.
please help thank you neal
-
Go back to your stock tune, raise the idle RPM a ~100 RPM, Do a search on RAFIG and RAFPN, that should help with the start up problems you are having...
-
i cant even get it to start on the stock tune now.
-
Joe (Moderator)
knucles,
Welcome to the forum.
It should be able to start and run even if it won't run properly.
Are you sure you're still getting plugs and injectors to fire...?
Are RPMs indicated while cranking...?
Are you sure there are no air leaks around the intake manifold (and it's various vacuum ports)...?
Start with your stock tune file, goto table B0101, increase the whole table by 10%.
-
be for i started with the efi it would start i checked the manifold for leaks and found none. i will try the 10
-
Joe (Moderator)
Put the original tune back in there and see if it starts.
(also, you should be doing cal-only flash and not full flash).
-
-
i have no clue it is the red arrow that goes down but says curent cal
-
Joe (Moderator)
-
yes that is the one that i have ben using. do i have to use that for every cal made individualy? or will i do all the cals that i have made sence the last time?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules