Where do I get connectors and the pin out for the V2 so I can use for voltage input?
Where do I get connectors and the pin out for the V2 so I can use for voltage input?
07 Silverado DMax Classic
02 Z06 LS3 416, 805rwhp, TFS245, Wiseco, Callies Crank/Rods, Iskendarian Lifters, Crower Rockers, FAST102/90, ATI Damper, 1-7/8 Kook's LT, QkTime Shield,Tolle-Fab 8pt
Old Engine: 1/4mile = 9.6/146 New Engine:?
EFI Live Tune/Scan v7.5.27, EFI Live Scan and Tune v8.2.23, build 276, BootBlock 2.07.06, FirmWare 2.07.52, 512K RoadRunner (12.14.R), Innovate Serial LC2x2
COS5/12212156 For 2002 Z06 Manual Vette
See the spare parts section in EFILive's online store:
http://www.efilive.com/pc-51-4-flash...-terminal.aspx
http://www.efilive.com/pc-52-4-flash...-terminal.aspx
Those two pages also show the Weidmuller part number.
However, I think Weidmuller only sell them in lots of 100.
Contact Ira at Fish Tuning (310) 499-0989 . He should have them in stock and won't make you buy 100 at at time
Regards
Paul
Before asking for help, please read this.