If you take a look in the file:
\Program Files\EFILive\V7.5\Configuration\cal_link.txt
you will see the setup for the LS1 VE table B1010
Code:
;Main VE Table
B0101.ROW=SAE.RPM
B0101.COL=SAE.MAP
B0101.RRR=CALC.BEN1,CALC.BEN2,CALC.BEN_AUT1,CALC.BEN_AUT2,CALC.BEN_FJO1,CALC.BEN_FJO2,
CALC.BEN_LC11,CALC.BENLC12,CALC.BEN_LM11,CALC.BEN_LM12,CALC.BEN_PLX1,
CALC.BEN_PLX2,CALC.BEN_TE1,CALC.BEN_TE2,CALC.BEN_WBC1,CALC.BEN_WBC2
What that means is, you need to log SAE.RPM and SAE.MAP and one of
CALC.BEN1,CALC.BEN2,CALC.BEN_AUT1,CALC.BEN_AUT2,CA LC.BEN_FJO1,CALC.BEN_FJO2,CALC.BEN_LC11,CALC.BENLC 12,CALC.BEN_LM11,CALC.BEN_LM12,CALC.BEN_PLX1,CALC. BEN_PLX2,CALC.BEN_TE1,CALC.BEN_TE2,CALC.BEN_WBC1,C ALC.BEN_WBC2
in order to use AutoVE and/or RTACS.
For an LC1 in analog mode (connected to A1), you would need to log:
CALC.BEN_LC11 (or if you connected it to A2, then you would log CALC.BEN_LC12).
The prerequisites for CALC.BEN_LC11 are:
GM.AFR for LS1 (this PID is different for E40, E38 and E67)
EXT.AD1
CALC.AFR_LC11
The prerequisites for CALC.BEN_LC12 are:
GM.AFR for LS1 (this PID is different for E40, E38 and E67)
EXT.AD2
CALC.AFR_LC12
For ANY wide band in digital mode (connected to RS232), you would need to log:
CALC.BEN1 (if you had 2 LC1s then you would ALSO log CALC.BEN2.
The prerequisites for CALC.BEN1 are:
GM.AFR for LS1 (this PID is different for E40, E38 and E67)
EXT.WO2AFR1
When you select a CALC.xxxx PID, you can see what other PIDs you need to select that it depends on by right clicking on it in the [PIDs (F8)] tab page and selecting More info...
For the High/Low octane spark maps:
Code:
B5913.ROW=SAE.RPM
B5913.COL=GM.DYNCYLAIR_DMA,GM.CYLAIR_DMA,GM.DYNCYLAIR,CALC.CYLAIR
Which means you need to log SAE.RPM and one of:
GM.DYNCYLAIR_DMA,GM.CYLAIR_DMA,GM.DYNCYLAIR,CALC.C YLAIR
I recommend using GM.DYNCYLAIR_DMA
Regards
Paul