just updated to v8
used efi explorer and inported log file from flashscan v2
log file are ls1 99+ auto
from 97 with 411 and van tune
how do i get these file to read
bbl log file say chanel count zero
just updated to v8
used efi explorer and inported log file from flashscan v2
log file are ls1 99+ auto
from 97 with 411 and van tune
how do i get these file to read
Start scantool and open file... scantool is under Program Files\EFILive\V7.5
Same with tunetool.
ya sorry that was what i was doing and it says channel count is 0 cannot load file
happy canada day
going to try again
Last edited by tokymon; July 1st, 2008 at 12:12 PM. Reason: added
How big is the log file...?
Can you post it here...?
That used to happen on an earlier version of the FlashScan firmware. Make sure you've upgraded your FlashScan firmware to V2.05.18.Originally Posted by tokymon
Regards
Paul
Before asking for help, please read this.
i think i found my problem i have bootbloc from april and v.05.18
is there updated bootbloc to flash it is the one that downloaded with v8.1
The latest boot block version is V2.05.08 (released April 25)
The latest firmware you should be using is V2.08.18 (correction: this should say 2.05.18)
Can you send me one of the *.efi files that says channel count is zero?
Send it to paul@efilive.com
Regards
Paul
Last edited by Blacky; July 2nd, 2008 at 04:14 PM.
Before asking for help, please read this.
okay theres my problem i have bootblock 2.5.08 and firmware 2.5.18
sorry i dont know how to post my datalogs
email sent to blacky thanks in advance for the help
You have the right versions, I types the wrong version numbers.
Regards
Paul
Before asking for help, please read this.
I have not received any email from you yet...
Regards
Paul
Before asking for help, please read this.
Posting Permissions
Reply With Quote