Installing the V8 Software

[ScarabEpic22]

Can you open up the V7.5 Tune tool, then click Help->Register EFILive. If your registration details are not populated, then re-enter them (make sure you select the proper License type- unless you have a V1 Personal select Commercial Scan&Tune). There was a problem with an earlier installer erasing the files in the My Documents\EFILive\V7.5 folder so it might have deleted your license file.

BTW, there is a new public version released just an hour ago. Get it here: http://forum.efilive.com/showthread....-March-29-2012

[mackthehack]

If I'm still unable to tune, then I will re-register.

Thanks man

[Tan70]

I have downloaded V7.5 and V8.
I checked for updates and it says everything is up to date.
I then tried to rip my stock file off my truck and i get an error code ($11).
Have no idea what is going on.

The bootblock and firmware say "go"

Please help.

Thanks.

[Blacky]

I have downloaded V7.5 and V8.
I checked for updates and it says everything is up to date.
I then tried to rip my stock file off my truck and i get an error code ($11).
Have no idea what is going on.

The bootblock and firmware say "go"

Please help.

Thanks.

Have you read through this page:
http://support.efilive.com/kb_articl...8254-QOGC-9586
If you send me the trace files as described on that page, I can take a look at what is going wrong.

Regards
Paul

[Tan70]

Its say it is in demo mode and wont allow me to view what is needed for that

[Blacky]

Its say it is in demo mode and wont allow me to view what is needed for that

Have you entered your FlashScan registration details from the blue License card into the EFILive software?
Once you do that, then the software won't be in demo mode anymore.

Or if you have your FlashScan device connected to your PC before starting the V7 software the software will not go into demo mode.

Regards
Paul

[Tan70]

ok it finally read it. do i pm you with what was read or post here?

[Blacky]

ok it finally read it. do i pm you with what was read or post here?

If you successfully read out the PCM then there's no need to post it here or send it to me, you're good to go.

If the read process still fails with code $11 or any other error code, then send me the appropriate trace files. Send them to paul@efilive.com.

Regards
Paul

[Tan70]

Just went and tried again, this time i recieved an $80 Bootlogger rejected.

[Tan70]

It can't successfully read the pcm.. I get the error $80. And I can't copy the trace to email it to you.