v2 still only logging for a few minutes..

[ringram]

Hmmm... interesting. Ill do some more checking then. Maybe the cable is dodgy, It does fall on the floor and generally thrown around at times.. the v2 that is.

[ringram]

Ok retested. On file close there was 348,000 frames done over about 90min
Saved file was only 6mb and only has the magic number of exactly 50,000 frames! The same as the last log...

V2 was still logging on the display when I closed the file off onto SD.

So looks like max file size is 50,000 frames. Firmware is dated 7 July as above.

http://www.systemsup2.plus.com/BBL00048.zip

Any news on this Paul?

[hrthsv]

I just checked my BBL log, the 500km one and it had 239,660 frames on the log, went from 9.30am to 4.06pm (with stops). For example 43.1 map at 1600rpm had 33,461 hits. So something is wrong with a setting somewhere. I am using a PLX WB without the digital upgarde maybe there is a difference with that?

[ringram]

No WB here yet, just 50k frames max. I cant see any settings anywhere regarding max frames, so Im at a loss to figure it out.

[swingtan]

I just checked your log file......

FRAMECOUNT=00178353

This was taken from the log metadata.

I can open the log in Scan-Tool and see the very last frame, 178352

Open the Scan-Tool and go to the following menu option,

Edit - Properties - Logging

In the box for "Frames (x1000)" enter something like 500, then click on "OK"

See if you get the results you are looking for


Simon

Edit: The reason this appears for E38 controllers is the increased frame fate over the LS1. The E38 will do 40FPS vs 10FPS for the LS1, so you get 4 times more frames for the same period of time.

[hrthsv]

Yes, I bet that's it when I was using the V2 as a pass through to the laptop I had to increase the frames or it wouldn't log more than 1 1/2 hours. Your V2 is probably BBL logging it but your scan tool when you download on the computer isn't displaying it.

[ringram]

Nice detective work!
That allows me to see 99,900 but it looks like there is a hard limit on that now. I tried all sorts of values. Im using 7.5.4 build 65. What are you using Swingtan?

[swingtan]

You are correct. there is a 1,000 (x 1000) limit to the number of frames to display. I queried this a while ago and then forgot about it, but the limit was supposed to be raised. RE: this thread.... http://forum.efilive.com/showthread.php?t=8103&page=3

I think it got missed in the final release though. I don't believe that there is a way to "split" a log file before displaying, but you should be able to select the section of the log not being displayed and "crop" the unselected porting from the log file. Once done, a "re-plot" should show the data, but don't forget to "save as" a new log file so you don't overwrite the original file.

The new ScanTool V8 should be much better at handling these big log files.

Simon

[XLR8NSS]

http://forum.efilive.com/showthread.php?t=8521

Check the link above about the 99,900 frame display deal.

[ringram]

Ok, good, so it crunches all the numbers, but only shows 99,900 in the display? I can live with that if thats the case.