i have a 2004.5 LLY w/ 5 speed allison. i have the HP at rear wheels PID validated and it does not have an X through it. so it should read during scanning. why does it always read 0 HP?
i have a 2004.5 LLY w/ 5 speed allison. i have the HP at rear wheels PID validated and it does not have an X through it. so it should read during scanning. why does it always read 0 HP?
1) Before logging, using the scanner software, go to File->Enter Vin:
Put in the kg or lbs of vehicle:
2) After log, use Notepad.exe to open the log.efi file and manual enter the GVW in kg. such as
To enter a 1564.894kg, enter it as 1564894 with no decimal points. Reload the graph and the hp data should be there.
07 Silverado DMax Classic
02 Z06 LS3 416, 805rwhp, TFS245, Wiseco, Callies Crank/Rods, Iskendarian Lifters, Crower Rockers, FAST102/90, ATI Damper, 1-7/8 Kook's LT, QkTime Shield,Tolle-Fab 8pt
Old Engine: 1/4mile = 9.6/146 New Engine:?
EFI Live Tune/Scan v7.5.27, EFI Live Scan and Tune v8.2.23, build 276, BootBlock 2.07.06, FirmWare 2.07.52, 512K RoadRunner (12.14.R), Innovate Serial LC2x2
COS5/12212156 For 2002 Z06 Manual Vette
thanks alot i just couldn't figure that out.