Using a 04 GTO pcm in my rx7 swap and the pcm only controls the high side. How can I wire them up to utilize both high and low? Is there any settings in the pcm or pin I can add to the pcm that allows me to run a setup like this?
Using a 04 GTO pcm in my rx7 swap and the pcm only controls the high side. How can I wire them up to utilize both high and low? Is there any settings in the pcm or pin I can add to the pcm that allows me to run a setup like this?
Take a look at the thread linked below ... was posted today.
http://forum.efilive.com/showthread....-Fan-Questions
Regards,
Taz