I read over the tutorial again and as far as I can tell you only need the V2 hooked to the laptop before you open the tune tool in order to see the VVE tables.
I am on 7.5.4 build 66 tune tool and firmware 2.5.20 for the V2.
The truck has an E38 ECM and a magnacharger TVS blown 6.0L. I have a 2 bar MAP sensor and need to get the VE table setup for 2 bar but, can't see the virtual VE tables in the tune.
I attached the trucks stock tune below.
Anyone have any ideas.
Thanks