A/F Close enough?
I've spent quite a bit of time logging and updating my VE table. It doesn't look like I can get it much better without my VE graph looking like crap. ( I was told its best not to have any lines crossing when looking at your VE graph in the 2D ) I've seen a few logs and a few dyno graphs where the AF looks MUCH better than mine.
I'm running clsd, I've considered reconnecting my MAF but dont know how to tune with the MAF. I've spent a couple hours searching/browsing so I know some people adjust the MAF calibration (b5001), some tune with the Injectors (B3701) and no one can agree on the right way to do itlol
Its just hard to know where to go from here.... Any advice would be Greatly appreciated!
The tune is set up for Logging VE BEN.
The log is a little In town driving and 1 WOT run 2-4 gear.
Reply With Quote