I'm not sure what I'm doing wrong but I cant seem to get this VVE process working. it either causes huge peaks in areas and huge dips in others unless I use the copy and fill process, but when I use that it seems to change my logged data to much and don't get the desired effect in AFR? I have tried to attached a log but it wont so here is the latest tune file after applying this BEN Map.
Clayton Mafless13.ctz
Last edited by jmsmotorsport; February 13th, 2016 at 06:55 PM.
Found my problem, if you set map precision to 3 any numbers over 1 become .025 ect if it's set to 2 the number shows 1.02. So every time I would paste and multiply it would cause issues. In the mean time any rich spots have been sorted but all the lean spots never changed as they would multiply by .025 cause a huge hole then get smoothed out once I would gem coefficient and vve
Would this tutorial apply to a 2015 Camaro SS with E38 ?
Thanks
~Erik~
2013 Sonic RS Manual - 1.4L I4T E78, tuned, turbo mods, etc.
2008 TrailBlazer SS 3SS AWD Summit White - LS2 E67/T42, bolt ons, suspension, etc.
2002 Chevy TrailBlazer LT 4X4 Summit White - 4.2L I6 P10, lifted, wheels, etc.
E92 requires a calc pid for MAP:BARO ratio (which is used to reference the axis of the VVE tables)...
i.e. define CALC.MAP_BARO to be {SAE.MAP.kPa}/{SAE.BARO.kPa}.
Make the MAF fail (i.e. force a MAF DTC immediately (you might have to increase the very low end of the MAF so engine can start and then throws a MAF DTC))... and go from there.
You mean link the scantool to the tunetool... there is a setting for this.
Oh, yes, there's a log joining tool somewhere, I don't remember where it is... if you have multiple logs, the joining tool joins them together... just try it, you'll see how it works.