I just updated to 7.5.5
I want to keep manvac in inHg. Is there a way I can switch that back to inHg? All there is now is kPa and PSI.
Am I left with just putting the older version back on?
I just updated to 7.5.5
I want to keep manvac in inHg. Is there a way I can switch that back to inHg? All there is now is kPa and PSI.
Am I left with just putting the older version back on?
You may need to create a calculated pid in calc_pids.txt to display MANVAC in inHg.
Is the pid in question GM.MANVAC...?
Is your calc_pids.txt file the default one or have you edited it before...?
If it's the original one, I can make you one later, I'll post it here.
yes, GM.MANVAC
default pid file.
Thank you!
Copy this file to either of (whichever one you have):
My Documents\EFILive\V7.5\User Configuration
My Documents\EFILive\V7\User Configuration
Then open scantool:
in PIDs tab, select both GM.MANVAC and CALC.MANVAC;
in charts/gauges, available pids are:
CALC.MANVAC.inHg
CALC.MANVAC.psi
CALC.MANVAC.kPa
thanks a ton!
I see what you did. Hopefully i can do the next one now!
Last edited by dlove; October 31st, 2008 at 04:50 AM.
Everytime, I tried to measure something with an inch of mercury is just puddles up so I just switched to kPa. Also, I was running out of peoples' feet to cut off for measuring things with so I went with meter sticks.