Results 1 to 2 of 2

Thread: Overly agressive knock sensors on stock 06' CTS-V

  1. #1
    Junior Member
    Join Date
    Sep 2005
    Posts
    25

    Default Overly agressive knock sensors on stock 06' CTS-V

    I finally got a chance to scan my stock LS2 CTS-V to see what's what. The first thing I noticed is a fair amount of KR (usually around 4-6 degrees) in the 1800-2500 RPM range at part throttle (mostly in the 30-55% TP range). At WOT, it's fine at all RPM's. I read some forums where people are saying the 06/07 LS2's had revised knock sensors that are more sensitive. Before I start making any changes, I wanted to get the general consensus here, and what if anything I should look at first. Just in case it was the issue, I pulled all the plugs, and swapped them out with NGK's which didn't help or hurt the issue.

    I have another scan at 55% throttle that does the exact same thing as the screen shot below in the same RPM range. It seems that everything above 55% and 2500 RPM is fine.

    Any thoughts? Excuse the missing PID's below. I just rebuilt my laptop and haven't had a chance to resetup everything.

    2008 Corvette Z06 - Stock until warrnty expires

  2. #2
    Lifetime Member hymey's Avatar
    Join Date
    Jan 2008
    Posts
    313

    Default

    They are sensitive but at the same time they tend to have to much timing in lower areas especially on the 6L.

Similar Threads

  1. No knock sensors???
    By hquick in forum General (Petrol, Gas, Ethanol)
    Replies: 14
    Last Post: July 9th, 2016, 07:28 AM
  2. Knock Sensors off
    By waterbug1999 in forum Gen III V8 Specific
    Replies: 12
    Last Post: September 12th, 2009, 03:12 PM
  3. 98 knock sensors
    By minytrker in forum General (Petrol, Gas, Ethanol)
    Replies: 1
    Last Post: June 10th, 2006, 10:12 AM
  4. LS2/LS7 Knock Sensors and LS1/6 PCM
    By bink in forum General (Petrol, Gas, Ethanol)
    Replies: 11
    Last Post: June 21st, 2005, 10:55 AM
  5. ls-2 knock sensors with ls1 computer?
    By koolrayz in forum General (Petrol, Gas, Ethanol)
    Replies: 23
    Last Post: December 7th, 2004, 09:55 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •