Results 1 to 5 of 5

Thread: Bouncing WB readin...

  1. #1
    Senior Member Naf's Avatar
    Join Date
    Aug 2006
    Posts
    183

    Default Bouncing WB readin...

    Ok, i have been tryin to tune my Tahoe with an LM7 engine. I installed a ls6 cam and Ls6 milled heads...

    I am startin to get the engine to open up, but my AFR isnt a nice constant line, not to mention once it warms up the AFR goes from 14.4~15.0 to 15.5...It bounces from 13~21 all the time, while in lite throttle, to heavy throttle. While i am at WOT it donesnt jump as much but the line still isnt smooth....My Cadi was tuned by a pro and the line is MUCH better then mine with the exact same setup for the WB.

    I have attached a copy of the tune as well as the Logs for comparison.

    American Muscle, European Design, Japanese Tactics

  2. #2
    Member
    Join Date
    Jul 2008
    Posts
    99

    Default

    Is the sensor new, old, damaged etc?

  3. #3
    Senior Member Naf's Avatar
    Join Date
    Aug 2006
    Posts
    183

    Default

    brand new lc-1 sensor and calibrated.

    It has me baffled, for it jumps to super lean
    American Muscle, European Design, Japanese Tactics

  4. #4
    Lifetime Member mr.prick's Avatar
    Join Date
    Nov 2006
    Posts
    3,195

    Default

    in my experience, when AFR spikes lean then goes back to normal
    like yours is doing it has been the sensor.

    i did not watch your log all the way through but,
    does the car feels like its fuel starved for that second?
    does it surge at that moment?
    one way to know for sure is if the sensor is to

    i just had to replace mine
    at WOT i saw AFR go super lean, the car pulled
    and had no KR or acted at all like it needed fuel.

    i have been getting only 1 year out of the Bosch 17014 sensors.

    also you might want to use the serial connection if you are using the V2.
    512k RoadRunner Firmware 12.14R
    FlashScan V2 Bootblock V2.07.04 Firmware V2.07.22 EFILive V7.5.7 (Build 191) V8.2.1 (Build 181)
    LC-1 WBO2

    _________________________________________________

  5. #5
    Senior Member Naf's Avatar
    Join Date
    Aug 2006
    Posts
    183

    Default

    The car continuously pulled, no hesitaition...

    I also notice something when i installed the new o2 sensor...It didnt get as hot as it did the first time. I think the controller is my problem...I will buy a new one and plug it in...

    Electronics are always a headache in trouble shootin...You never know when they go bad...
    American Muscle, European Design, Japanese Tactics

Similar Threads

  1. RPMs bouncing at 2-3 shift!
    By shadyst in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 1
    Last Post: June 8th, 2009, 07:50 PM
  2. timing bouncing in maf only tune
    By Aint Skeered in forum General (Petrol, Gas, Ethanol)
    Replies: 23
    Last Post: January 13th, 2009, 06:40 PM
  3. Bouncing off rev limiter
    By TransTech in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: November 11th, 2007, 06:09 PM
  4. bouncing idle
    By killaz in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: June 17th, 2006, 11:12 PM
  5. Spark Bouncing Around At Idle
    By BowlingSS in forum General (Petrol, Gas, Ethanol)
    Replies: 4
    Last Post: February 17th, 2006, 02:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •