Results 1 to 3 of 3

Thread: hydro fuel cell tuning w/efilive

  1. #1
    New Member
    Join Date
    Dec 2008
    Posts
    1

    Question hydro fuel cell tuning w/efilive

    2004 5.7 gto I had this car up to 29.8 mpg but pcm rejects piggy back computer tuning so I'd like to try this efilive program can I control map,maf,cts,iat,upstreams,downstreams and fuel trims from idle to wot without any performance problems?

  2. #2
    Lifetime Member
    Join Date
    May 2008
    Posts
    368

    Default

    Hi, welcome to the efilive forums. Your vehicle is supported.

    You can download a copy of the software from here to look at all the settings you can play with:
    http://www.efilive.com/index.php?opt...=48&Itemid=124

    You can find a close match to your vehicles original tuning here to open with efilive:
    http://holdencrazy.com/EFILive/stockTunes.php
    2003 Chevy S10 4.3L LU3 LS1B Auto
    48 LB injectors
    Race Proven Motors 2114 intake
    T70 turbo.

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    scadnv, welcome...

    You can edit:
    - VE (airmass) table
    - MAF (airflow) table
    - IFR and related tables
    - OL air fuel ratio table
    - PE and PE enable tables
    - MAF, MAP, ETC sanity tables
    - CL mode and O2 switch point tables
    - Stoichiometric AFR
    - Spark tables
    - and more

    Tell us more about your car.

Similar Threads

  1. Fuel trim cell boundries / zones?
    By JAY4SPEED in forum E37, E38 & E67 PFI ECM's
    Replies: 0
    Last Post: September 21st, 2009, 03:00 PM
  2. Fuel Trim Cell Issue with 7.5
    By MoTruck in forum General
    Replies: 0
    Last Post: February 2nd, 2008, 05:26 AM
  3. Fuel Trim Cell PID
    By VetPet in forum Petrol / Gas
    Replies: 5
    Last Post: April 9th, 2007, 05:24 PM
  4. LS2 fuel Trim Cell# and Engine Zone1_DMA
    By MICK in forum Gen IV V8 Specific
    Replies: 1
    Last Post: February 22nd, 2007, 03:59 AM
  5. Fuel Trim Cell 10
    By eboggs_jkvl in forum General (Petrol, Gas, Ethanol)
    Replies: 7
    Last Post: December 20th, 2005, 11:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •