order question

[mr.prick]

Did you set the wideband type to AEM?

[wesam]

yes i set the wide band to AEM UEGO
when i try to log using the V2 it said Controller not found

[wesam]

i connect pin number 2 in the to the blue serial cable coming from the AEM WB
and pin number 5 grounded to the same point with the WB is this correct ?

[joecar]

Can you mark up this pic to show how you connected your AEM...

[wesam]

here is how i connect it

[joecar]

Try connecting the blue wire to pin 3 on the DB9 connector.

[wesam]

i don't think it will work because pin 3 is for calibration ( for sending data not for receiving data ) in Innovate WB
and AEM don't have calibration feature

[joecar]

The Tx pin might actually be a receive pin.

[wesam]

The Tx pin might actually be a receive pin.

ok i will try this today

i noticed some thing weird when i tried to calibrate the FS V2 settings as in the
Serial Wideband Tutorial i did not get the COM In : WBO2 and COM OUT : WBO2
as in this picture is this because i have the latest version of the firmware

[joecar]

Yes, the latest firmware has change that, the doc has not yet caught up.